Kaput® Rat and Mouse Bait MSDS July-03
|
Manufacturer: Scimetrics
Ltd. Corp. Fort
Collins, CO. 80524 |
Prepared
By: TS |
Telephone
No: 970-482-1330 |
Emergency
Phone No: Medical:
800-858-7378 Transportation 800-424-9300
(CHEMTREC) |
|
|
Product
Name: Kaput® Rat and Mouse Bait |
Use: Anticoagulant
Rat and Mouse Bait |
Bait
Form: Loose Grain |
||
|
SECTION 1. HAZARDOUS
INGREDIENTS |
||||
|
Active
Ingredient: Warfarin |
Percent
by weight: 0.025 |
CAS
#: 81-81-2 |
EPA
Reg #: 72500-6 |
|
|
SECTION 2. PHYSICAL DATA |
||||
|
Appearance: Green Grain |
Color: Blue/Green |
Odor: Grain |
Solubility: N/A |
|
|
Vapor
Density N/A |
Melting
Point N/A |
Water
Reactivity N/A |
Evaporation
Rate N/A |
|
|
Vapor
Pressure N/A |
Boiling
Point N/A |
Specific
Gravity 1.0 |
Bulk
Density N/A |
|
|
SECTION 3. HEALTH HAZARDS |
||||
Primary Route of EntryIngestion,
Skin & eye contact, skin absorption |
Signs and Symptoms of ExposureNausea,
vomiting, loss of appetite, extreme thirst, lethargy, diarrhea, bleeding |
|||
Emergency First Aid Procedures
Eyes: Flush with water for 15
minutes. If irritation persists,
consult a physician Skin:
Wash
thoroughly with soap and water. Ingestion: Call a physician or
emergency telephone number immediately.
Do not give anything by mouth or induce vomiting unless instructed by
a physician. Inhalation: N/A |
||||
Note to Physician: If ingested,
administer Vitamin K1 intramuscularly or orally as indicated in
bishydroxycoumarin overdoses. Repeat
as necessary based on monitoring of prothrombin times.
|
||||
|
SECTION 4. FIRE FIGHTING
MEASURES |
||||
Flash PointN/A |
Flammable LimitN/A |
|||
|
Extinguishing
Media For
small fires, use water spray, carbon dioxide, dry chemical powder, or foam |
||||
|
Special
Fire Fighting Procedures: Firefighters should be
equipped with protective clothing and self-contained breathing apparatus. |
Unusual
Fire and Explosion Hazards: None Known. |
|||
|
SECTION 5. ACCIDENTAL
RELEASE MEASURES |
||||
|
General
Information: Wear
personal protective (gloves) and sweep up and store in plastic labeled
container with lid for disposal. |
||||
|
Spills
/ Leaks: Wipe
up spill, place in a plastic container, and hold for waste disposal. |
||||
Page
2: Kaput® Rat
and Mouse Bait MSDS
|
SECTION 6. HANDLING AND
STORAGE |
|||
Storage TemperatureRoom temperature |
Average Shelf LifeBait is stable for a
minimum of 1 year when stored correctly at room temperature |
||
Special SensitivityAvoid
exposure to excessive heat or cold. |
|||
Precautions in Handling and StorageStore
in original container in a cool, dry area inaccessible to children, pets, and
wildlife. Avoid contamination of
lakes, streams and ponds. Wash
thoroughly with soap and water after handling. |
|||
|
SECTION 7. EXPOSURE
CONTROLS AND PERSONAL PROTECTION |
|||
|
Respirator
Type: None required |
|||
|
Eye
Protection: None
required |
Gloves:
(Recommended): Rubber
Gloves |
Ventilation:Not
required |
|
Other Protective MeasuresNot
required |
|||
|
SECTION89. STABILITY AND
REACTIVITY |
|||
|
Stability: Stable |
Conditions
to Avoid:
None |
||
|
Polmerization: Will not occur |
Conditions
to Avoid:
None |
||
|
Incompatibility
(Materials to Avoid): Strongly alkaline materials |
|||
|
SECTION 9. TOXICITY INFORMATION |
|||
|
LD50
Oral Ingestion: >5000 |
LD50
Dermal (Skin Contact): >2000
mg/kg (rats) |
LC50 Inhalation:N/A |
|
Dermal Sensitization:Not
Considered a Sensitizer |
Skin Irritation:Non-Irritating |
Eye Irritation:Non-Irritating |
|
|
SECTION 10. ECOLOGICAL
INFORMATION |
|||
|
Published
data demonstrated lack of secondary toxicity when 250 ppm warfarin baits fed
to rats, then rats fed to magpies and carnivores. |
|||
|
SECTION 11. DISPOSAL
CONSIDERATIONS |
|||
|
Wrap
in newspaper and discard in trash. |
|||
|
SECTION 12. TRANSPORTATION
INFORMATION |
|||
DOT Shipping NameNone
required |
|||
DOT Hazard ClassificationNon-Hazardous |
|||
DOT Labels Required
None
required |
Freight ClassificationLTL
Class 60 |
||
|
SECTION 13. REGULATORY
INFORMATION |
|||
|
This
product is subject to EPA FIFRA regulations. |
|||
|
SECTION 14. OTHER
INFORMATION |
|||
|
Warranty: Information provided in
this Material Safety Data Sheet has been obtained from sources believed to be correct to the best of our
knowledge but is not all inclusive and shall only be used as a guide.
Scimetrics Ltd. Corp. shall not be held liable for any damage resulting from
handling or from contact with the above product and provides no warranties
either expressed or implied and assumes no responsibility for the accuracy or
completeness of the data contained on this form. |
|||